More LED information, please click Real Green Lighting Company Limited
1, the installation distance between the projector and should not be too close, when the lighting installation is too dense, will enable lighting temperature.
2, the temperature is too high the lamp ballast temperature rise exceeds the allowable range of lead ballast, lamp life is shortened, the occurrence of burning lamps and sockets or internal space cracking phenomenon.
3, the temperature rise of the lamp by the size factor, the size of lamps and lighting arrangement, as well as construction, the impact of the internal space of the lamp material, please refer to the following for proper installation:
Proper lighting installation interval.
Increase the space inside the lamp.
Luminaire body set up around vents.
Do not use ballast mounted.
Interior ceiling ventilation.
4, the installation location and other lamps and curtains to avoid contact with combustible materials.
An upper temperature for
1, the installation distance between the projector and should not be too close, when the lighting installation is too dense, will enable lighting temperature.
2, the temperature is too high the lamp ballast temperature rise exceeds the allowable range of lead ballast, lamp life is shortened, the occurrence of burning lamps and sockets or internal space cracking phenomenon.
3, the temperature rise of the lamp by the size factor, the size of lamps and lighting arrangement, as well as construction, the impact of the internal space of the lamp material, please refer to the following for proper installation:
Proper lighting installation interval.
Increase the space inside the lamp.
Luminaire body set up around vents.
Do not use ballast mounted.
Interior ceiling ventilation.
4, the installation location and other lamps and curtains to avoid contact with combustible materials.
An upper temperature for
5, very high gas appliances, lamps should maintain an appropriate distance from the heat source, such as kitchen installation location, heat lamp distance should be above 1 meter.
6, mounting direction rain-type lamps are specified direction, it must be installed in accordance with the specified direction to prevent water intrusion.
7, the installation type and moisture rain lamp, should note the following:
A, mounting surface and the lighting installation must be part of the rubber gasket adhesion.
After B, if uneven mounting surface, ambient lighting installation position fill-in lighting installation.
C, pay attention to the appearance of the mouth power outlet whether there is danger of flooding.
8, reinforced concrete surface lighting device, must wait for concrete surfaces really dry, if not confirmed before the installation of lighting and dried, after lighting installation, concrete moisture will be absorbed by the lamp, resulting in reduced insulation, lighting painting face off.
6, mounting direction rain-type lamps are specified direction, it must be installed in accordance with the specified direction to prevent water intrusion.
7, the installation type and moisture rain lamp, should note the following:
A, mounting surface and the lighting installation must be part of the rubber gasket adhesion.
After B, if uneven mounting surface, ambient lighting installation position fill-in lighting installation.
C, pay attention to the appearance of the mouth power outlet whether there is danger of flooding.
8, reinforced concrete surface lighting device, must wait for concrete surfaces really dry, if not confirmed before the installation of lighting and dried, after lighting installation, concrete moisture will be absorbed by the lamp, resulting in reduced insulation, lighting painting face off.
No comments:
Post a Comment